![]() The sensitivity or range setting means how sensitive the motion sensor is to minor motion and how far it can detect. ![]() Set the time setting to the lowest or select the test mode. In test mode, some motion sensors may additionally flash a red light to inform the users a motion has been correctly detected. On some motion sensor lights, you might find a “test” or “test mode” labeled in the timer settings, which is basically the same thing as a very short time setting. When testing the motion sensor, we need the time setting to be as low as possible, so the motion sensor light turns off very quickly for us to test again. The time, timer or on-time settings means how long the light is kept on after the motion is no longer detected. Normally you may find these options: Time or Timer or On-Time Now we can adjust the motion sensor settings for testing.ĭepending on various models, you may find different options available on the light. Adust the Motion Sensorįirst, we need to warm up the motion sensor light for around 90 seconds after the light is initially powered up. This might also cause your motion sensor light to falsely turn on and not turn off. When the motion sensor is not placed properly, the PIR motion sensor might be able to passively receive infrared signals from moving traffic, wild animals or air conditioners which may give out heat signals and get identified as a valid motion, hence triggering the PIR motion sensor to turn on the light. When adjusting the motion sensor, make sure that the motion sensor cannot be triggered by motion from other distractions other than the detecting area. If you are using a motion sensor detector added to a light, together as a motion sensor light, the motion sensor should not be placed too close to the light bulb, at least 2 inches away, in case they will end up influencing each other. For the initial positioning, angle and point the motion sensor lens to where you want to detect motion. When positioning the motion sensor, we aim to make the motion sensor entirely and only target and cover the detection zone. For a motion sensor spotlight or porch light, you can aim and position the light bulb socket to target a specific area that you want to illuminate. ![]() Adjust the light bulb holders up and down, left and right, till you can roughly get a good position that can light up your entire yard. In most cases, we want the light to have the broadest illumination coverage, such as the security floodlights. We don’t aim for perfect positioning here because we’ll fine-tune them later. Initial Positioningīefore making adjustments to the motion sensors, the first thing is to align and position the motion sensor lights. Always refer to your user instruction for the final settings and recommendations from the manufacturer. This guide is a general guideline for you to follow when adjusting the motion sensor lights. Without proper adjustment, a motion sensor light not only will not work to its full potential to detect people and motion effectively, but also it can falsely activate or turn off the lights, which may cause unwanted trouble at night. The battery and solar-powered lights are even faster to mount and install, requiring nearly little to no handwork.Īfter installing an outdoor security light, the first thing to do is to set up the motion sensor correctly for the best settings. Home DIYers can replace and install a hardwired motion sensor light within 30 minutes, even for a complete beginner. Motion sensor lights are energy-friendly, convenient to use and easy to install.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |